![]() it has not occurred since the firmware update. But since we update to the latest ATEM firmware. This is happened lately more and more frequently. Te ATEM switcher by unplugging the power cable and returning it again after 5 seconds. This is also displayed on the multiview output for all inputs. After a XX number of hours, is the program output pink with green and red stripes. We need to update our atem from blackmagic design because we had a major problem with our 1M/E 4K atem. ![]() But, we can't connect to the atem if the atem use firmware version higher than 6.9 in Just Macros Lucky we download justmacros version 75 plus before the justmacros site goes down. If someone has documentation on justmacros and the implemantion to a production studio (Atem switchers, BM Videohubs, Casper CG), I'm very grateful for help! Since the justmacros page is down as well as atemuser I was hoping to find a little help here. Write of address 00000044ģ1 Jan 11:39:24.434: TVISATEMMacroMixer.Destroy: Error clearing Command Stack Access violation at address 0098353F in module 'JustMacros63Plus.exe'. This is the error message I receive when trying to connect our ATEM 2M/E:Ĭode: Select all 31 Jan 11:39:24.434: TVISATEMMacroMixer.Destroy: Error Stopping Stacked Command Processing: Err: Access violation at address 0098330B in module 'JustMacros63Plus.exe'. Unfortunately I can't even get the atem connection working. For our live production studio I wanted to implement justmacros.
0 Comments
Leave a Reply. |